User's Manual

Menu Mode

and static data received from all vessels within VHF range, during a

voyage, including your own vessel’s data.

Note In order to use the Data Logging function, you will require an SD card.

The installation procedure of the SD card, can be found in section 2.8.

5.6.6.1 Enabling

To enable data logging on your AI50, first you have to select a data file

name, that the information will be stored under.

From the System Setup menu select “Data Logging”, and press  MENU

or ►. A window opens displaying the options as shown in Fig. 5.18.

Select “Log File Name” and press  MENU or ►. The “File Name” is

highlighted. Using the ▲▼ keys cycle through the predefined names

(AISLOG1 to AISLOG10), then press  MENU or ► to select one.

Highlight “Enable Logging” and press  MENU or ►. A tick will appear

in the box and the file name will be greyed out. All data for your voyage

will now be stored under this file name.

Note If you enter this menu with a log file open, you will only be able to end logging.

Pressing the ◄ key returns you to the previous menu and a pop-up

window informs you that the file has been created.

Logging is now enabled, all information being received will now be

recorded onto the installed SD card, under the selected file name.

If you have omitted to fit an SD card into your AI50 or you have a

non compatible SD card, when you try to enable logging the following

Fig 5.18 – Logging menu