User Manual

5
LD2342 V1.3 Page 5 of 16
SRT Marine
User guide
SRT-MTB
©
proAIS Application
User guide
AIS Connection
1. Wire one end of the supplied RS232 cable into the connector block on the NAIS-300, refer to Figure 2.1 of the manual.
Plug the 9-pin RS232 connector into the serial port on your PC or laptop.
2. Launch the proAIS application by navigating to the 'proAIS' shortcut on the Start Menu.
3. The initial application screen will appear as shown below (exact screen display depends on version installed)
4. The application requires a serial connection to an NAIS-300© transponder. Connect the transponder to an available
serial port.
5. Select the serial port from the drop down menu, then click 'Connect':