USER MANUAL Navigon Bluetooth CSR BC5-MM Solution Bluetooth Module
Contents Section One: Introduction 1 1.1 Features 1 1.2 Hardware Requirements 1 Section Two: Bluetooth Installation 3 2.1 ActivePerl Installation 3 2.2 Bluetool Installation 2.3 Driver in BTWUSB The information contained in this manual has been verified at the time of this manual printing. The manufacturer reserves the right to make any changes and improvements in the product described in this manual at any time and without notice. All registered trademarks are the property of their respective owners.
Section One: Introduction This module is with CSR BlueCore5-Multimedia External solution. It is a single-chip radio and baseband IC for Bluetooth 2.4GHz systems. When used with the CSR Bluetooth stack, it provides a fully compliant Bluetooth v2.1 + EDR specification system for data and voice. BlueCore5-Multimedia External contains the Kalimba DSP co-processor with double the MIPS of BlueCore3-Multimedia External, supporting enhanced audio applications. 1.1 Features 1.1.
Section Two: Bluetooth User This module is used a standard UART interface for communicating with other serial devices. BlueCore5 Multimedia External UART interface provides a simple mechanism for communicating with other serial devices using the RS232 protocol. When BlueCore5 Multimedia External is connected to another digital device, UART_RX and UART_TX transfer data between the two devices.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device is intended only for OEM integrators under the following conditions: The transmitter module may not be co-located with any other transmitter or antenna, As long as the condition above is met, further transmitter test will not be required.
