Operation Manual

User’s manual NAVIGON 63xx

Switching on the NAVIGON 63xx - 15 -

3 Switching on the NAVIGON 63xx

1. Press the (On/Off) key and keep it pressed until the device

switches on. (Approx. 1,5 seconds)

If password protection has been activated, the E

NTER PASSWORD

window opens.

2. Enter the password.

3. Tap on OK

The N

AVIGATION window opens.

When you start the navigation application for the first time, the

EMO MODE settings window opens.

Demo mode is intended only for demonstrating the product when no

GPS reception is possible.

When demo mode is active, navigation is not possible! Demo mode

is designed solely to simulate navigation to the centre of the

indicated destination.

4. Make sure that the Start in Demo Mode

setting is at No. If

necessary tap on the

(Toggle), button in order to change the

setting from Yes

to No.

5. Tap on OK

Note: When you switch on the NAVIGON 63xx for the first time, you

will be asked to make the following settings:

► your preferred language for using for the software

► the unit of length for distances

► the time format

Note: If you have not used the NAVIGON 63xx for a long time, the

battery may be flat.

In this case the device must first be connected to the car charger cable

or to a suitable charger before it can be switched on. Chargers and

other accessories are available in the NAVIGON shop at

www.navigon.com

or in specialist stores.

Forgotten your password?

If you enter the password wrongly three times, a window will open with

instructions telling you what to do now.

► Follow the instructions on the screen.

Switching the navigation device to standby mode

► Press briefly (max. 1,5 seconds) on the (On/Off) key.