GPS Navigation Receiver User's Guide
Table Of Contents
- End User License Agreement (EULA)
- Contents
- Introduction
- Welcome
- Getting Started
- Basic Operations
- Starting the NAVIGON 8100T
- Viewing device status
- Using Keyboards
- Using menus
- Security
- DirectHelp
- Using Voice Destination Entry
- Destination Selection
- Using auto-complete to select a destination
- The Search Area Tab
- Search Areas
- Ways to Search for Destinations
- Entering an address
- Selecting a Point of Interest (POI) destination
- Selecting a Direct Access POI
- Searching for POIs Near a Selected Location
- Selecting a destination by tapping the map
- Starting navigation
- Arriving at your destination
- ZAGAT POIs
- My Destinations
- Routes
- Maps
- NAVIGON Lifetime Traffic
- Hands-Free Operation (Bluetooth)
- Logbook
- Customization
- Legal Notices
- Technical Data
- Index
Using Voice Destination Entry
Setting Up Voice Destination Entry to Recognize Your Voice
December 2008 NAVIGON 8100T User’s Guide 45
Version 1.1 NAVIGON, INC.
6. Tap OK.
The M
AIN WINDOW re-displays.
You can now start using voice entry to select destinations.
Restarting Audio Assistant
If you reset your NAVIGON 8100T or if another person will be using the device, you
should run Audio Assistant again.
From the V
OICE ENTRY MAIN WINDOW:
1. Tap Options > Audio Assistant.
2. See “Setting Up Voice Destination Entry to Recognize Your Voice” on page 44 to
set up voice recognition.
Select Audio Assistant Volume
From the VOICE ENTRY MAIN WINDOW:
1. Tap Options > Settings.
The A
UDIO ASSISTANT SETTINGS WINDOW displays.
The orange boxes indicate the volume.
2. To increase the volume, tap (Toggle). The more orange boxes, the louder
the volume.
3. To decrease the volume, tap (Toggle) to increase the volume until the all
boxes are orange. Tap again to clear all of the orange boxes and start at the low-
est volume setting.
4. When finished, tap OK.