User's Manual
Table Of Contents
- Table of contents
- 1 Introduction
- 2 Before you begin
- 3 Switching on the NAVIGON 81xx
- 4 Password Lock
- 5 Operating the NAVIGON 81xx
- 6 Navigation
- 6.1 Starting the navigation application
- 6.2 Specifying a destination
- 6.2.1 Specifying the country in which the destination is situated
- 6.2.2 Entering an address
- 6.2.3 Selecting the destination address by voice command
- 6.2.4 Points of interest
- 6.2.5 Information about the destination
- 6.2.6 Last Destinations
- 6.2.7 Favourites
- 6.2.8 Contacts
- 6.2.9 Navigating home
- 6.2.10 Selecting destinations on the map
- 6.2.11 Starting navigation
- 6.3 Managing destinations
- 6.4 Multi-leg routes
- 6.5 Options in the navigation application
- 6.6 Working with the map
- 6.7 Useful functions
- 7 Handsfree Module
- 8 Music
- 9 Pictures
- 10 FM Transmitter
- 11 Configuring the NAVIGON 81xx
- 12 Appendix
- 13 Troubleshooting
- 14 Index
User’s manual NAVIGON 81xx
- 12 - Before you begin
Note: When the bluetooth function of the NAVIGON 81xx is active, the
LED shines with a blue light. This is also the case during charging.
For detailed information refer to chapter "Handsfree Module" on
page 51.
Note: It takes approx. 4-5 hours to charge the device when the battery
is flat.
2.4.3 Memory card
A memory card with the software and card data is already inserted in
the navigation device.
You can copy these data to another memory card or save them on your
PC. To do so, use the NAVIGON Fresh software which is included on
the CD provided or can be downloaded free of charge from
www.navigon.com
.
The following memory media can be used in the NAVIGON 81xx:
► SD cards with maximum 2 GB
► SDHC cards
Removing the memory card
1. Switch off the navigation device. To do so, press the
(On/Off)
key.
2. Press the memory card gently into the device until the lock
disengages.
3. Let go of the memory card. It will now project slightly out of the
device.
4. Pull the memory card out of the slot.
Inserting a memory card