Datasheet

User’s manual NAVIGON 8410
Working with the map - 53 -
Rename: Opens a window in which you can change the name for the selected
destination or route.
Traffic
: Opens the TRAFFIC INFORMATION window in which pending reports are
listed. (Refer to "TMC (Traffic Information)" on page 77)
Turn
-by-Turn List
: Shows detailed directions for the route, including all points at
which you must turn. (Refer to "Turn-by-Turn List" on page 76)
Save Destination
: Saves the selected address in the FAVOURITES list. (Refer to
"Saving destinations" on page 44)
Add to Route
: Opens the route planning. The address specified will be added as
a route point. (Refer to "Multi-leg routes or tracks" on page 45)
Interim Destination
: Sets the selected point as interim destination. The
navigation system will first guide you to this interim destination.
Afterwards you can continue navigation to your original destination.
9 Working with the map
9.1 Selecting the navigation map
Each country has its own navigation map. Seamless navigation over
several maps on one continent is possible however if a continuous
route can be calculated with the maps saved on the device.
Even if maps of countries in other continents are available on the
navigation device, the NAVIGON 8410 can only ever work with the
maps of a single continent.
Tap in the N
AVIGATION window on Options > Settings > Map Display in
order to see which maps are currently in use. Here you can also select
a different continent if the navigation device contains any maps of
countries on other continents.
9.2 Map in Standard mode
The map is always in Standard mode when you are not navigating,
have not calculated a route and are not searching for a destination on
the map.
Under the following circumstances the map switches automatically to
Standard mode:
► You begin a trip while the NAVIGATION window is open. The switch
takes place after only a short while.
► You reach the destination of a navigation in Vehicle mode.