Installation Instructions

14 NAVMAN G-PILOT 3380 System Installation Manual
Installing a electric drive motor with clutch relay
In the Setup > Vessel menu (See G-PILOT 3380 system Operation Manual), set Drive Type to Motor.
Installing a continuous running pump and solenoid valves.
In the Setup > Vessel menu (See G-PILOT 3380 system Operation Manual), set Drive Type to Spool ground.
Fit strain relief
Wiring polarity does
not matter.
Motor
MCU600
Clutch
coil
1N4002 diode or equivalent. Fit
close to relay coil
1N4002 diode or equivalent
Fit close to relay coil
Relay coil
MCU600
1N4002 diode or equivalent
Fit close to relay coil
Relay contacts
Relay coil
Starboard
Port
Motor
Fit strain relief
Heavy duty power (see section 3-4-1)
Heavy duty power (see section 3-4-1)
Wiring polarity does
not matter.
Note: Motor is not
required for engine PTO
systems.
Relay contacts
Note: Relay is required if the clutch
circuit is greater than 300 mA.
Note: Relay is required if the
clutch circuit is greater than
300 mA.
Connector cover
Connector cover