Installation Instructions

16 NAVMAN G-PILOT 3380 System Installation Manual
3-5 Installing the RFU (rudder feedback unit)
Physical
10 m (33 ft) cable
Arm
90 mm
(3.5”)
220 mm
(8.7”)
Base
Linkage to
rudder
Rudder
shaft
Arm rotates freely
around base.
LT8 connector
These two
distances to
be equal.
Connecting rod, with quick
release fittings and lock
nuts each end
End of connecting rod
snaps into one of the
holes on the arm.
Mounting requirements
These two
distances to
be equal.
Base to be adjacent to
rudder shaft so that this
angle is 90°
Rudder shaft to be
parallel to shaft in
base.
Rudder linkage and
arm to move in the
same plane
Note
The unit is completely waterproof but should not be immersed.
Mount the unit on a panel which does not vibrate.
Follow the location guide (see section 3-2-1).
Adjust position of rod on
arm if required.
Cut connecting rod
if required.
Thread = M5