Installation Instructions

G-PILOT 3380 System Installation Manual NAVMAN 5
To verify that the G-PILOT 3380 system is
operating correctly, perform sea trials (see
section 5).
Cleaning and maintenance
Clean the parts of the G-PILOT 3380 system
with a damp cloth or mild detergent. Avoid
abrasive cleaners, petrol or other solvents.
Do not paint any part of the G-PILOT 3380
system except for the cables.
1 Introduction
Using this manual
This manual describes how to install and set up
the G-PILOT 3380 system. Refer to the separate
G-PILOT 3380 Operation Manual for information
on how to operate the G-PILOT 3380 display unit.
To install a G-PILOT 3380 system, you must
perform installation, dockside setup and sea
trials (see sections 3, 4 and 5).
To fully set up a G-PILOT 3380 system after a part
has been changed or if a problem is suspected,
perform dockside setup and sea trials again
(see sections 4 and 5).
Manual helm
GPS
NMEA
SPEED
WIND
Display
unit
Light duty
Heavy duty
12 V DC
Power supply
Gyro
Compass
MCU600
NavBus
Clutch drive
(optional)
Parts supplied with G-PILOT 3380 system
Other parts required
Optional parts
Rudder
feedback
unit
Rudder
Power switch or
switches and
power protection
Rudder
control
Key
1-1 A typical G-PILOT 3380 system installation
Optional instruments
Note: Above shows typical installation
only. Please refer to the information
supplied with your drive for further
information.
More
display
units
Steering
drive