Operation Manual

12
TRACKER 5430/5430i Installation and Operation Manual
NAVMAN
3-1-1 Chart modes
The Chart has two modes, centre on boat mode
and cursor mode. These are explained below.
Centre on boat mode
To switch to centre on boat mode in the chart
display, press ESC. The boat is at the centre of
the chart. As the boat moves through the water,
the chart automatically scrolls to keep the boat
in the centre of the chart. The cursor (see below)
is turned off.
Cursor mode
The keys , , and are called cursor keys.
To switch to cursor mode in the chart display,
hold down a cursor key. The cursor
appears and
moves away from the boat:
Press the key which points in the direction
that the cursor will move, for example press
to move the cursor down.
Press midway between two of the cursor keys
to make the cursor move diagonally.
Hold a cursor key down to make the cursor
move continuously across the display.
In Cursor mode:
The distance (+DST) and bearing (+BRG) of
the cursor from the boat are displayed at the
bottom, left corner of the display.
The chart does not scroll as the boat moves.
If the cursor reaches the edge of the display,
the chart will scroll.
For example, hold down to move the
cursor to the right side of the display and the
chart will scroll to the left.
3-1-2 Latitude and longitude
Latitude and longitude can be displayed at
the top of the chart. Normally the position is
the boat’s position, and the latitude has a boat
symbol to show this:
The chart. To change
the types of information
displayed, (see section
13-2).
Compass display
(see section 3-1-4).
To turn the compass off
or on, see section 3-1-8.
Boat course and CDI
lines (see appendix
C, CDI)
Boat is going to the
waypoint called
FISH06.
Data display. To turn
the data off or on or to
change what data is
displayed, see section
3-1-8.
Boat position
(see section 3-1-1)
Boat track
(see section 3-5)
Typical waypoint
(see section 9).
A typical chart display shows:
Distance and bearing of
cursor from boat.
The cursor
(see section 3-1-1).
3-1 Chart display
Sea
Land
Chart is in cursor mode, press ESC to return to
centre on boat mode (see section 3-1-1)