Operation Manual

16
TRACKER 5430/5430i Installation and Operation Manual
NAVMAN
To use the fuel display, the optional fuel kit must
be installed and the fuel data set up (see section
13- 4).
To go to the fuel display, press DISP and select
Fuel.
The fuel display shows:
Used: The total fuel used since it was reset to 0
by the Clear Used command (see section 13-4).
Remaining: The amount of fuel remaining in the
fuel tank(s).
Flow: The fuel consumption. For twin engine
installations, the fuel flow for each engine is
shown separately. This is useful for checking that
both engines are under the same load.
Economy: The distance travelled per unit of fuel
used. The units are set by the units selected
for speed and fuel. Adjust throttle and trim for
best economy. The bigger the number the better
the economy.
Speed: Boat speed over ground.
Range: The estimated distance that the boat
is able to travel, based on fuel remaining and
current fuel consumption.
4 Fuel display
Warnings:
Fuel economy can change drastically depending on boat loading and sea conditions. Always
carry adequate fuel for the journey plus a sufficient reserve.
Each time fuel is added or removed use the fuel setup menu (see section 13-4) to record the
fuel or else fuel remaining and the low fuel alarm will be meaningless!