Operation Manual
19VHF 7000, 7100US, 7100EU Operation Manual
NAVMAN
4. Press ENT (repeatedly if necessary) to display the YES/NO conrmation.
5. Press ENT to conrm the new channel name tag or the deletion, then press ESC to return to
the menu.
3-3 RING & BEEP Volume (RING VOLUME)
& (BEEP VOLUME)
Set the volume level of the incoming signal beeps (RING VOLUME) and/or the error and warning
beeps (BEEP VOLUME) to HIGH (high) or LOW (low) as follows:
1. Select RADIO SETUP, then RING VOLUME or BEEP VOLUME as appropriate.
2. Select a HIGH or LOW volume. (It is possible to turn the beeps off completely by selecting
BEEP VOLUME then OFF.)
3. Press ENT to enable the new volume setting and return to the menu.
3-4 Internal Speaker Connections (INT SPEAKER)
Switch the radio’s internal speaker ON (on) or OFF (off). The external speaker is always ON (on)
if a speaker is plugged into the external speaker jack.
1. Select RADIO SETUP, then INT
SPEAKER.
2. Select ON (on) or OFF (off) then press
ENT to enable the setting and return to
the menu.
3-5 Set the Priority Channel (WATCH MODE)
If you have a VHF7000 or a VHF 7100EU, watch mode is similar to a dual watch, scanning
between the priority channel and the working channel. CH16 is the priority channel.
However, if you have a VHF 7100US and are operating on USA or Canadian channel banks,
you can set the priority channel to cover both CH16 and CH09 as well as the working channel,
as follows:
1. Select RADIO SETUP, then WATCH
MODE.
2. Select ONLY 16CH for dual watch
mode, or 16CH+9CH for tri watch
mode.
INT SPEAKER
>ON
OFF
RADIO SETUP
RING VOLUME
BEEP VOLUME
>INT SPEAKER
RADIO SETUP
CH NAME
>RING VOLUME
BEEP VOLUME
RING VOLUME
>HIGH
LOW
BEEP VOLUME
>HIGH
LOW
OFF
RADIO SETUP
BEEP VOLUME
INT SPEAKER
>WATCH MODE
WATCH MODE
>ONLY 16CH
16CH+9CH