Owner manual

-6-
General information about the remote control
1. Removing insulating sheet
The remote control comes with an insulating
sheet attached to the underside of the remote
control as illustrated on the right
The remote control is disabled and will not work
until the insulating sheet is removed.
as illustrated on the right
.
2. Replacing the lithium cell
If the electric energy of the lithium cell is weak,
replace it .
1. Press and hold the movable block in the
direction indicated by arrow 1 , at the same
time pull the cell holder out of the remote control
in the direction indicated by arrow 2 .
2. Replace the old cell with a new one with (+)
polarity side upward .
3. Insert the cell holder into the remote control again.
3. Note about using the remote control
1. Face the emitting window of the remote control towards the sensor window of
the unit.
2. Operation angle for front panel: About 30 degrees
3. The distance between the emitting window of the remote control and the sensor
window of the unit : < 5M .
4. Warning for lithium cells of remote control
leakage may cause damage to remote control.1.Cell
2.Do not throw cells into fire, it may cause an explosion.
3.To avoid accidents, keep cells out of reach of children.