User Manual

Safety equipment in the NBB-radio remote control:
In the transmitter
In the receiver:
Ifthe NBB radio remote controlis not used for a long period,it is urgently recom-
mended that the batteries be charged now and again (about every 4 weeks).
This prevents deep discharges of the batteries and prolongs their useful life. If
you shut down the NBB radio remote control for a long period, we recommend
you take the battery out of the transmitter.
Frequency change Planar-H, -S, -V and Pocket-A, -B, -F, -S, -V:
Frequency change Pocket-D:
,thiscomprisesmainly:
STOP (transmitter ON/OFF), resp. EMERGENCY STOP with automatic disconnection
of the power supply.
Automatic zeropositioning.
Two diversity units for evaluation of the STOP, resp. EMERGENCY STOP signal.
Automatic zerosetting when switching back on after radio interruption.
Locking of the radio commands at relay level in the event of a defective STOP, resp.
EMERGENCY STOP circuit.
To ensure fau lt- free operation, ple ase fo llo w prec ise ly the f oll owin g r ules for ope rati on:
The unit to be controlled can only be switched on - it is assumed that the transmitter is
ready to operate - when no command unit is actuated. The command necessary to do so
is triggered by the key "ON/HORN". This triggers a horn signal in the unit to be controlled.
After switch-on of the facility to be controlled, this key is used for repeated emission of the
horn signal in accordance with working regulations.
To change the f requency, keep the "ON/HO RN" key pres sed down. Th en operate the "FRE-
QUENCY CHANGE" key. Ifthereceiverlocks into the new frequency, a horn signal is given
(if present) and the unit to becontrolled is ready for operation.*
To di splay the active f re quency kee p bo th keys (below right and below left) pressed down
at the same time for at least 3 seconds. The current frequency channel is flashing on the
display. Then let both keys go.
Now the frequency can be changed from channel 1 to channel 67 by pressing the upmost
keys ("+" or "-").* The first step of the keys changes the channel gradually one by one. The
second step of the keys allows a quick change of the channel.
By pressing the key below right the channel number is taken over, saved and the frequen-
cy display mode is finished. The unit is ready for operation again.
*Pleaseobservetheparticularpostalapprovalregulations oftheconcernedcountry.
%
%
%
%
%
LED RADIO ON
LED BATTERY
FREQUENCY CHANGE
Page 5
S
T
O
P
STOP
RADIO ON /HORN
Pocket-A
Pocket-B
RADIO ON /
EMERGENCY STOP
Pocket-D
Pocket-F
Pocket-S
Pocket-V
Pocket-V-3
Pocket-V-9
6. OPERATING THE UNIT
2.4
88
2.4
88
4.5
88
+
The active frequency
is displayed.
The frequency can be
changed.
The frequency is taken over
and saved.
The transmitter is ready for
operation again.
Pocket-D
STOP
L.
Planar-H
KEY FREQUENCY
CHANGE
KEY
ON / HORN