Users Manual

10
Transmitter Nano-media
Operation of the system
> Switching the transmitter on and off
– Unlock the emergency stop pushbutton by turning clockwise to switch on the transmitter.
– Two acoustic signal sounds.
– A red dot flashes in the LED display.
– Switch off the transmitter by pressing the emergency stop pushbutton once.
After pressing the emergency stop pushbutton, the transmitter sends stop telegrams for
2 seconds to switch off the system. This shut-off time is displayed on the LED display by
the external segments rotating clockwise.
To ensure faultless free operation, please observe the following rules:
The system to be controlled – provided the transmitter is ready for operation – can only
be switched on if no command is activated. To start the system to be controlled and to
activate the functions press the “On/Horn” button, which also triggers a horn signal.
Due to work specifications, the same button is used for triggering repeated horn signals.
> Frequency change
To change the frequency, press and hold the “On/Horn” button. Now press the
“Frequency change” button. Each press advances one channel. If the receiver locks on a
new frequency, a horn signal is triggered and the system is ready for operation. Please
observe the country-specific regulations.
> Channel number
During operation the set channel can be displayed by pressing the “Frequency switching”
key.
Operation:
The red dot flashes.
Information symbols:
Frequency change
On/Horn