User's Manual

2-26 Chapter 2: Installing the Hardware Infrastructure
21398
5
White
White
Black
Black
2
1
3
White
Black
Note: Colors shown are for recommended Belden
cables. Your wire colors may be different.
7
8
4
6
21953
3
3. Plug the connector into the power supply.
4. On the CBS, unplug the power connector.
5. Install the power cable wires into the connector (white into pin 1, 3,
5, 7 or 9 [48 V] and black into pin 2, 4, 6, 8 or 10 [Ground]). Use
pins in pairs: 1-2, 3-4, 5-6, 7-8, and 9-10 for each power cable
connection at the CBS.
6. Plug the connector back into the CBS.
7. Insert the AC power cable into the power supply's AC receptacle.
8. Connect the AC plug to the AC power source.
9. Turn on AC power by setting switch to ON position. (Green light
indicates that power source is working properly).
Caution: To prevent damage to the transmitter, the transmit antenna
must be connected to the CBS before applying power to the CBS.