User's Manual

2-30 Chapter 2: Installing the Hardware Infrastructure
2. Screw the 63.5 mm (2.5 in.) antenna stud into the 1/4-20 UNC hole
in the back of the antenna.
3. Route the antenna cable through one hole in the ceiling tile and the
antenna stud through the other hole.
4. Place the 31.75 mm (1.25 in.) fender washer on the antenna stud
and screw the 6.35 mm (0.25 in.) wing nut onto antenna stud until it
firmly holds the antenna against the ceiling tile.
5. Connect the antenna cable as follows:
• Transmit antenna - Attach the 1.83 m (6 ft.) Transmit antenna
cable to the CBS.
• Receive antenna - Connect one end of the Receive antenna cable
to the CBS. Attach the Receive antenna pigtail to the other end
of the Receive antenna cable.
6. Use cable ties to secure the antenna cable.