User's Manual

Chapter 3: Maintenance 3-5
If using DHCP – change reservation so new MAC address is
reflected
8. Start the RealPrice System software.
9. Use the RealPrice Support Utility or CBS Setup utility to set the
CBS Timeslots and verify the Frequency Hopping Table does not
conflict with the existing CBSs.
10. Check the Diagnostics information for the new CBS using the
RealPrice Support Utility or CBS Setup utility.
Make changes to firmware, if mismatch – before upgrading any
CBS, read firmware release notes
Verify Country Codes match
Check Transmit Power Levels
Not 0 (zero)
Within a range of +/- 10
11. Use the dncalib utility to verify CBS is functioning in the coverage
area where the CBS was replaced.
12. Confirm that errors related to the replaced CBS are no longer being
logged.
13. Run dncbsstatus utility to obtain new dncbsstatus.out file.
14. Upload results of all tests and files noted above to the CKS2000 web
site.
Adding a CBS
Use this procedure when adding a CBS to an existing installation to
extend or increase the coverage area.
1. Stop the RealPrice System software.
2. Power off all the CBSs in the system by powering off the power
supplies.
3. Add Ethernet and power supply cabling to extend the existing
network.