User's Manual

3-6 Chapter 3: Maintenance
4. Install CBS Transmit and Receive Antenna(s), and antenna cables as
required for the new CBS.
5. Install the new CBS and connect the cables.
6. Power up all CBSs in the system.
7. Use the RealPrice Support Utility or CBS Setup utility to make the
necessary changes to the dncbsconfig.xml file to identify the
new CBS IP Address or Host Name.
8. Start the RealPrice System software.
9. Use the RealPrice Support Utility or CBS Setup utility and enable
Normal Mode communications.
10. Use the RealPrice Support Utility or CBS Setup utility to set the
CBS Timeslots and CBS Hopping Table frequencies for the new
CBS.
11. Check the Diagnostics information for the new CBS using the CBS
Configuration utility or CBS Setup utility.
12. Use the RF Certification Utility and certify the RF coverage area of
the new CBS. Refer to the RealPrice RF Certification Utility Guide
(AIP-000269) for detail.
Replacing Antennas
Replacing a Receive Antenna
Use this procedure to replace a suspected malfunctioning receive
antenna.
1. Disconnect and remove the malfunctioning receive antenna.
2. Install and re-connect the new receive antenna.
3. Use the RealPrice Support Utility or CBS Setup utility and check
the Diagnostics information for the CBS where the new antenna
was installed.
4. Use the dncalib utility to verify CBS is functioning in the coverage
area where the new antenna was replaced.