User Manual Chapter 3

Chapter 3: Installing the Hardware Infrastructure 3-19

Ethernet Hub. Standard 4 pair, CAT5, 24 AWG solid, unshielded,

plenum rated cables are required for all Ethernet communications.

1. Locate the Ethernet hub.

2. Cut a length of data cable that is long enough to reach from the hub

to the primary CBS.

3. On each end of the data cable, install the wires into an RJ45

connector as shown in the following illustration and then crimp the

connector onto the cable.

18959

To Ethernet Hub

or CBS III Hub

To CBS III

Hub

RJ45

Connector

Blue/White

Orange

Orange\White

Green

RJ45

Connector

Note: Colors shown are for recommended Belden

cables. Your wire colors may be different.

Blue/White

Orange

Orange\White

Green

Blue

Green/White

Brown

Brown/White

Belden Wire Colors

RJ45 Pin Color RJ45 Pin Color

1Orange 5Blue

2 Orange/White 6 Green/White

3Green 7Brown

4 Blue/White 8 Brown/White

4. Plug the data cable into the Uplink data connector on the primary

CBS.