Owner manual

TACTICAL RED DOT SIGHT

 This tubeless design reflex lens aperture provides a wide field of view providing

quick target acquisition which makes it suitable for rapid-firing and shooting of

moving targets. This reflex sight will be suitable for many projectile-firing

devices including handguns, shotguns, rifles, air guns, and crossbows.

 The red dot is factory-adjusted parallax free to 40 yards. This adjustment ensures

that parallax-related aiming errors are minimized over a large range distance.

 Items provided with your new sight include a cover (to protect your red dot while

not in use), two different sized allen wrenches, an extra battery, and a lens

cleaning cloth.

 The red dot is equipped with a standard on/off switch which can be found on the

rear of the sight body. While not in use be sure that the unit is covered and the

switch is off to preserve battery life.

MOUNTING:

 CAUTION: BEFORE BEGINNING INSTALLATION OF YOUR RED

DOT SIGHT BE SURE THAT THE FIREARM IS UNLOADED. ALWAYS

PRACTICE SAFE FIREARMS HANDLING PROCEDURES.

Your new tactical sight is equipped with an integral rail mounting system that is

designed to fit on any standard weaver-style base. To install, first loosen the two

allen screws on the right side rail using the provided allen wrench (3). Next, set the

sight on top of the base. Notice that one of the screws is protruding from the bottom

of the sight, be sure that this lug fits into one of the grooves of the weaver-style base.

This will ensure stability upon recoil of the firearm. Your tactical sight has unlimited

eye relief so you may mount it in the position that is most comfortable for you. Be

sure not to mount the sight to close to your eye as injury may result upon recoil of the

firearm. Once you have chosen the sight position that best suits you be sure that the

sight is fully seated on the base. Proceed to carefully tighten the allen screws (3)

firmly in place, but do not over tighten. Your new tactical sight is ready for zeroing.

PAGE 1
TACTICAL RED DOT SIGHT This tubeless design reflex lens aperture provides a wide field of view providing quick target acquisition which makes it suitable for rapid-firing and shooting of moving targets. This reflex sight will be suitable for many projectile-firing devices including handguns, shotguns, rifles, air guns, and crossbows. The red dot is factory-adjusted parallax free to 40 yards. This adjustment ensures that parallax-related aiming errors are minimized over a large range distance.
PAGE 2
ZEROING: WHEN OPERATING ANY TYPE OF FIREARM ALWAYS USE PROPER EYE AND EAR PROTECTION. BE SURE TO USE YOUR FIREARM IN AN AREA THAT IS PERMISABLE UNDER LOCAL, STATE, AND FEDERAL LAW. CAUTION: LOOKING DIRECTLY AT THE SUN THROUGH THIS SIGHT MAY RESULT IN PERMANENT EYE DAMAGE. Before making any adjustments to the windage and elevation (5 and 6), be sure to loosen the two locking screws (7) on the rear of the sight body to avoid damage to the internal components of the sight using the provided allen wrench.
PAGE 3
PAGE 4
2. LENS 5. ELEVATION ADJUSTMENT SCREW 4. ALLEN SCREWS 1. ON/OFF SWITCH 3. WEAVER BASE ALLEN SCREWS 7. LOCKING SCREWS 6. WINDAGE ADJUSTMENT SCREW COMPONETNS: 1. 2. 3. 4. 5. 6. 7.