RED DOT SIGHT WITH BUILT IN LASER ITEM# DLB140R INSTRUCTIONS
Red Dot Sight with Built in Laser Item# DLB140R PLEASE FOLLOW ALL OF THE DIRECTIONS IN THIS MANUAL CAREFULLY. CAUTION: ALWAYS PRACTICE SAFE FIREARMS HANDLING! BE SURE THAT THE FIREARM IS UNLOADED BEFORE PERFORMING ANY OF THE FOLLOWING PROCEDURES! BE SURE THAT THE FIREARM IS POINTED IN A SAFE DIRECTION AT ALL TIMES! CAUTION: AVOID DIRECT EYE EXPOSURE TO LASER BEAM! The DLB140R is a compact optical system packed with many features, and is also very user friendly.
FEATURES: Unlimited eye relief Black anodized aluminum construction Built in fully adjustable laser sight Five brightness settings for Red Dot Sight Ability to use Red Dot or Laser Individually, or both at the same time Built in Quick Release Mount for use with most Weaver Style/Picatinny rails LED (Light Emitting diode) 100% safe for the eyes SPECIFICATIONS: Length: 4.35” Width: 3.45” Height: 3” Weight: 11.3 oz.
1. Begin by loosening the Mount Locking Nut (12) on the left side of the mount. To perform this action, be sure that the Quick Release Lever (10) in the closed position pointing towards the eyepiece. Using a wrench, turn the Mount Locking Nut (12) counter-clockwise. 2. Next, turn the Quick Release Lever (10) to the open position pointing towards the objective lens. Using a small flathead screwdriver, loosen the Mount Set Screw (11) in order to fit the mounting unit to the rail on your firearm.
Knob (5) will turn on the laser sight only. The letter “B” will allow the user to turn on both the laser sight and the red dot sight at the same time. After you are done using the DLB140R, make sure that the Rheostat Knob is set to “0” in order to preserve battery life. ZEROING YOUR RED DOT SIGHT ADJUSTING WINDAGE AND ELEVATION: Your DLB140R is equipped with adjuster turrets for Windage and Elevation. The Elevation Adjuster (8) is located on top of the Sight Tube (1).
CAUTION: WHEN OPERATING ANY TYPE OF FIREARM ALWAYS USE PROPER EYE AND EAR PROTECTION. BE SURE TO USE YOUR FIREARM IN AN AREA THAT IS PERMISABLE UNDER LOCAL, STATE, AND FEDERAL LAW. 1. From a steady rest position (such as a shooting bench) fire three to five rounds at a target. 2. Observe where the bullets have struck the target and adjust windage and elevation as necessary until your point of aim matches your point of impact. 3. Your firearm and sight are now zeroed.
Lithium Battery type CR2032 only. Twist the Battery Cap (6) back on to the Rheostat Knob (5) and hand tighten. Avoid using tools (such as pliers) to perform this procedure as this may cause damage to the unit. CARE AND MAINTENANCE Your DLB140R is a sealed unit, please do not attempt to take it apart or clean it internally. The exposed optical lens surfaces will perform their best if they are routinely cleaned with a lens brush and the lens cloth provided with your sight.
NcSTAR DLB140R Red Dot Sight with Built in Laser FOR TECHNICAL ASSISTANCE CALL: 1-866-NcSTAR-8 (1-866-627-8278) WWW.NCSTAR.