- Networking Dynamics Corporation CompuFax User Manual

50
1 = Run Length Encoding
0 = No Compression
If the / BEST_WAY qualifier is also enabled, the actual method used may vary between zero and the number
selected above.
/NOTE
Format: / NOTE="string"
Description: Specifies a message string of up to 131 characters, which will print at the top of the flag
page, provided the / FLAG qualifier has been enabled.
/NOTIFY
Format: / NOTIFY (D)
/ NONOTIFY
Description: Controls whether a message will be broadcast when the printing of a fax file starts and
completes.
/ QUEUE
Format: / QUEUE=queue-name[:]
Description: This qualifier determines the queue name of the fax printer queue. If not specified, the
default queue name is FAX$PRINT. If the fax printer is also the system printer, you may wish to change the
queue name to SYS$PRINT or other queue name. In any case, the name specified must exist as an actual
print queue name. Refer to VMS documentation on how to create print queue.
/ RECEIVE
Format: / RECEIVE
/ NORECEIVE (D)
This qualifier determines whether received faxes are printed. The default is / NORECEIVE, since not every
system may have a fax printer. When using the / NORECEIVE printer option, it is recommended also to
disable the receipt of faxes altogether, since received data can soon fill up a disk. See the DEVICE command
help on how to do this.
/SCALE
Format: /SCALE (D)
/ NOSCALE
Description: The resolution of a typical laser printer is 300 dots per inch while a fax image is about 200
dpi, which would cause printing to occur at about two-thirds of the correct dimensions. The / SCALE
qualifier adjusts the size of the image. Where reducing system overhead is more important than the
dimensions of the printed image, you may prefer to use / NOSCALE.
/SEND
Format: /SEND
/ NOSEND (D)
Description: This qualifier determines whether sent faxes will be printed. This feature may be used to
check what faxes are being sent. Printing starts immediately after file conversion; therefore this option does
not guarantee that a printed fax has in fact been sent successfully. In addition to this feature, a / PRINT
qualifier has been added to the SEND command, which permits a single outgoing fax to be printed.
/ SHEET_FEED
Format: / SHEET_FEED
/ NOSHEET_FEED (D)
Description: When you wish to print on a different size or stock of paper than what is loaded in the tray,
you may set this qualifier to / SHEET_FEED, in which case the printer requires a manual start from the
control panel prior to printing each page.