- NDC Communications Network Card User Manual

How to Use this Guide
The User’s Guide gives complete instructions for installation and use of the
InstantWave Access Point (AP), Wireless Workgroup Bridge (WWB) and Wireless
Ethernet Client (WEC). All of them share a common user interface. The major
difference among them is:
• The AP has MAC address access control of the wireless stations
• The WWB‘s supports up to 16 Ethernet devices. An access table is
provided by the WWB to allow 16 Ethernet devices’ MAC addresses
to be registered.
• The WEC supports one Ethernet attached device.
InstantWave products are supplied with factory set default network settings. Use
the IWMS tool to change the default settings before introducing a new device to an
already-established wireless network.
The IWMS program is a simple-to-use, yet extremely powerful, SNMP-based
utility for online central configuration and network management from a remote
station on the same subnet. A trap management program is also provided to
monitor/diagnose InstantWave products.
InstantWave 11Mbps WWB/WEC
15