- NDC Communications Network Card User Manual

When all the settings are made, click OK to return to the SNMP Access Control
card.
Trap Server
Trap Management allows you to setup the configuration of the Trap Server
program. When a WWB (or WEC) is powered on, or its Ethernet port becomes
active, the WWB (or WEC) will send messages to the assigned trap server to report
these activities.
To assign a trap server, click New/Edit Trap Server (Figure 23). Assign a station
as a trap server by entering its IP address and network port type. Click OK.
To remove a trap server from the list, highlight it and click Delete. Click Delete
All to remove all assigned trap servers from the list.
Figure 23. Configuration/Trap Server
When the WWB (or WEC) is powered on, or an Ethernet port becomes active, an
event log will be generated indicating the time, the MAC ID of the reporting WWB
InstantWave 11Mbps WWB/WEC
43