User's Manual

D-POS User Manual NE41 07105-02 v1.0

3.5 LED Indicaon

There are three light eming diodes (LED) in D-POS. The acvity LEDs - LED1 and

LED2 - are red. The power LED - LED3 - is green. When the D-POS unit is powered

on, all three LEDs light up for one second. LED3 burns with a steady green light as

long as the power supply is OK and the D-POS unit is working without problems.

When the unit is working correctly, LED1 is blinking when antenna 1 is transmit-

ng and LED2 is blinking when antenna 2 is transming.

If LED3 is blinking with a green light, an error has been detected with the power

supply or the antennas, or the D-POS unit is broken or the lid is open (tamper

switch is open).

If LED1 is blinking with a red light and LED3 is blinking with a green light, there is

a problem with antenna 1. If LED2 is blinking with a red light and LED3 is blinking

with a green light, there is a problem with antenna 2.

3.6 LOOP Antenna

A LOOP Antenna is an electrical cable in a loop creang an electrical eld. Max

cable length <10 meters and cable area >0.4 mm

(AWG 21).

4 Installaon

1. To change the conguraon of D-POS, remove the lid and make sure the

AC/DC adapter is unplugged. Change the sengs of rotary switches, DIP

switches and jumpers as described on page 6 in this manual.

2. Connect a D-POS ANT to screw terminals 1 & 2 OR a LOOP antenna to screw

terminals 2 & 3.

To use both D-POS ANT and a LOOP Antenna connect D-POS ANT to screw

terminals 4 & 5 and then the LOOP Antenna to screw terminals 2 & 3.

3. If a magnec contact switch is used, connect it to screw terminals 8 & 10.

4. If the RFID eld from two D-POS units overlap, connect a synchronizaon cable

to screw terminals 9 & 10 on both D-POS units.

5. Connect the AC/DC adaptor to screw terminals 6 & 7.

Only use AC/DC adaptor provided by NEAT or use 12-24 V

as central

power supply.

6. Close and fasten the lid using the screws supplied.

7. Plug in the AC/DC adaptor in a mains outlet in the apartment.

8. The power LED lights up with a steady green light to indicate power is on.

To adjust the rotary switches we recommend a at screwdriver with a 2.4 x 0.5

mm blade. Use max. 10 meters of cable with cable area 0.4 mm

or more (AWG

21) for ferrite and loop antennas.