Use and Care Manual

Installation Instructions for NeatHeat Baseboard Covers:
**Please read all instructions prior to attempting installation. Baseboard heaters have sharp metal edges
which can cause serious injury. Use of personal protective equipment such as heavy gloves and safety glasses is
imperative when working on or around baseboard heaters.
Step 1: Check the “How To Measure For NeatHeat” guide below to make sure your individual baseboard
heaters are the correct size for NeatHeat. Common brands include Slant Fin series #15, #30, and #2000,
Sterling series petite 7, Suntech, and Weil Mclain; however there are also many lesser know brand names so it
is always best to check your specific measurements.
A = The measurement from the wall to the front edge of the metal enclosure attached to the wall. This measurement
must be 2” or less.
B = The measurement from the wall to the front edge of the heating element with the original face panel removed.
This measurement must be 3” or less.
C = The measurement from the floor to the top of the original cover. This measurement must be 6 ¾” or greater; if not
back plate must be raised.