Quick Start Guide

INDOOR HOTSPOT QUICK START GUIDE
Indoor Hotspot Quick Start Guide
Box Contents
Your Nebra Indoor Helium Hotspot comes with the following items:
• The Nebra Helium Indoor Hotspot
• RP-SMA LoRa Antenna
• Worldwide 12V 1.5A Power Adapter
• 1M CAT5 Ethernet Cable
Warnings
Please remember to follow the following steps when using your Nebra Indoor
Hotspot.
• Never power on the Indoor hotspot without it’s antenna connected as this
may damage the unit.
• Do not place in direct sunlight or on hot surfaces (e.g a Heater).
• The Indoor unit’s case is designed to be used indoors, and is not suitable
for use outside.
Preparing Your Nebra Indoor Hotspot
Step 1: First screw in the included antenna into the connector on the back of
the hotspot.
Step 2: Next find a suitable location for your Hotspot to be positioned, to
provide the best coverage we recommend placing it near a window just out of
direct sunlight. You’ll need to be near a mains power source too.
Step 3: If you are using a wired Ethernet connection, connect an Ethernet cable
between a router or switch and the Ethernet jack on the Hotspot.
Step 4: Fit the appropriate power plug for your country onto the universal
power supply and plug it into a mains outlet.
Step 5: Finally connect the DC Jack from the power supply into the power
receptacle on the Hotspot.
You should then see the lower LED on the back of the unit turn on, the hotspot
will now take up to 5 minutes to configure for it’s first boot.
The upper light will turn on when it is ready to continue for configuration.
If you have connected it to a wired Ethernet connection this process may take
slightly longer as it’ll also perform firmware updates as soon as it gets a connection
to the internet.
1 Nebra LTD. 2021