Quick Start Guide

Table Of Contents

INDOOR HOTSPOT QUICK START GUIDE

Conﬁguring Your Nebra Indoor Hotspot

To conﬁgure your Hotspot you will require the Helium Network application

installed on a Mobile Phone and for you to have gone through the account setup

process to continue.

Step 1: Open the Helium application and login, then press hotspots.

Step 2:

Next click Set up Hotspot , from here you will want to select Nebra

Indoor Hotspot.

Step 3:

After following the steps on the App to get to this page, Push the

button on the back of the unit once to enable pairing and then press scan on

the App.

Step 5:

Press the entry for your hotspot in the app, you can check it is the

correct one by matching the last 6 characters shown in the application with the

last 6 characters of the mac address printed on the sticker on the bottom of the

hotspot.

Step 6:

The app will show the available Wi-Fi networks within range of your

Hotspot.

If you are using Ethernet, tap Use Ethernet Instead and skip to Step 7.

If using Wi-Fi,

tap on the name of your Wi-Fi network on the app which will

bring you to the following screen.

Type in your Wi-Fi’s network password then tap Connect and it should connect

to your wi-ﬁ network.

Step 7: The app will then ask for you to set your hotspot’s location.

Step 8:

Finally you can conﬁrm the location of your hotspot. Click continue

and you should be presented with a map to then place where your hotspot is on

the app.

Step 9:

The setup should now be complete, it’ll submit the details of the

Hotspot to the Helium network and then in approximately 15 minutes conﬁrm

it’s added to the network.

2 Nebra LTD. 2021