Instruction Manual

Important Safety Instructions
Mounting Motorized projector Screen
3 421
Read and understand all instructions before you use
this device. Do not make any changes or settings that
are not described in this manual. If physical injury, loss
of data, or damage is caused by failure to follow
instructions, the warranty does not apply.
1. Make sure the ceiling or wall can bear the load of the
screen.
2. Do not place the screen near the devices with signal
sources or fluorescent lamps, as these can interfere
with the projected image. The beam will cause
misoperation.
3. Do not expose the screen to fire as it is not fireproof.
4. Power off the device before removing the power
supply from the socket.
5. Unplug the device if there are lightning storms or
when unused for a long period of time.
6. Because a dirty or scratched projection screen will
hurt the projection effect, please note the following:
Motorized projector Screen
Quick Start Guide
● Do not touch the screen with hands.
● Do not write or draw on the screen.
● Do not scratch the screen using your nails or sharp
objects.
● Do not clean the screen with corrosive chemicals
including diluent.
● Put the screen away after use.
Motorized projector Screen
Quick Start Guide
The Motorized projector Screen screen can be mounted on
the wall or ceiling. Before mounting the screen, make sure
you avoid placing the screen in direct light.
To mount the screen:
1. Draw a level line on the wall to mark the position for
mounting the screen.
2. Drill a hole into the wall at each marking.
3. Mount the mounting plate (not provided) using the
anchors and screws. Anchors are not needed for wooden
walls. Make sure these two mounting plates are mounted
at the same level, or the screen will skew to one side.
4. Hang the screen from the hook on the mounting plate.
7. Improper installation of the screen may result in
injuries or damage to the device. Nebula will not be held
responsible for any loss, incidental, or consequential
damage.
8. Clean the screen regularly.
4
2
3
4. Power off the screen when it is not in use.
Note:
● Before rolling the screen, check the screen carefully
and make sure there is no dust or foreign objects
which may damage the screen.
● DO NOT roll up and down the screen continuously
each time. Let the device that powers the screen cool
down before use.
● Make sure there is enough space to fully open the
whole screen.
Using Motorized projector Screen
1. Draw a level line on the wall to mark the position for
mounting the screen.
2. Let the projector screen be energized, there will be a
buzzer sound to show that the screen has been energized.
3. Use the remote control or switch on the screen to
control the screen.
● To raise the screen, press the “Up” button;
● To lower the screen, press the “Down” button;
● Press the “Pause” button to fix the screen in its
current position.
Pause
Down
Up
Accessories
Motorized screen *1PC
Remote control*1PC Manual *1pc
M6 expansion bolt *2PC(Celling Mounting)
Expansion rubber stopper*2PC
M5x40 Screw *2PC
Attention : Please note the voltage of the screen,
then connect the correct voltage power
.