User's Manual Part 3

INSTALLATION ROI-S05750
2-94
Chart 2-19 Terminating IF Coaxial Cable
with N-P Connector (Straight Type) used for
ODU IF IN/OUT (KOMINE made)
N-type connector is used for the ODU side.
Note: When the N (Male) straight connector is
attached to the IF
coaxial cable for the IDU IF IN/OUT, use of the TNC (Male) - N
(Female) (NJ-TNCP-LA) L-angle adapter is needed.
Step Procedure
1 The clamp nut, the washer and the gasket are inserted in the
cable,
GASKET
WASHER
CLAMP NUT
CABLE
2 Strip the cable as below and disentangle the braid and insert the
clamp in the cable,
BRAID
CLAMP
25 mm
Do not scratch the braid wire.
3 Turn the braid on the clamp inserted and cut the braid according
to the paragraph,
BRAID
INSULATOR
FOIL
PARAGRAPH