User's Manual Part 3

ROI-S05750 INSTALLATION

2-101

Chart 2-22 BNC Connector for 3C-2V Coaxial Cable

Assembling, Crimping Type

The following explains how to assemble BNC crimping type as an example.

Step 1. Strip coaxial cable as illustrated

left, (taking care not to damage

braided shield wire),

Step 2. Cut braided shield wire (without

unravel the strands of braid) and

trim it,

Step 3. Cut dielectric, (be sure not to cut

or scratch the centre conductor

while stripping the dielectric),

center conductor

dielectric

shield wire

Sheath

(15 mm)*

(6.3 mm)*

(4 mm)*

STRIPPING

Note*: Stripping measurements vary depending on the

BNC type.

contraction sleeve

ferrule

pin contact

BNC shell

BNC plug

contraction sleeve

ferrule

Step 4. Slide contraction sleeve and

ferrule onto the cable,

Step 6. Slide pin contact until it bottoms

against the centre conductor,

insulator

Step 6. Slide braid tube and insulator

among braided shield wire and

dielectric,

braid tube

Step 5. Fan braided shield wire,

braid tube

insulator

pin contact