User's Manual Part 3

INSTALLATION ROI-S05750

2-80

Chart 2-15 Terminating IF Coaxial Cable with TNC-P

Connector (L Angle Type) (HIROSE made)

ed for IDU IF IN/OUT

Step Procedure

Note: It is recommended that TNC (Male) L-angle connector for the

8D-FB IF cable is used to connect it to the IDU. When the N

(Male) straight connector is attached to the 5D-FB or 10D-FB

IF cable, use of the TNC (Male) - N (Female) (NJ-TNCP-LA)

L-angle adapter is needed.

1 Pass the tightening nut, the washer and the ga

sket on the cable in

the order shown in the figure.

Then, strip the cable jacket in the diameter show

n in the figure.

[Applicable cable : 8D-FB-E]

Note: Be careful of insertion direction for the gasket and the tightening nut.

Note: Be careful not to dama

ge the outer conductor.

Note: Do not reuse the gasket because the clamp deforms

it after

tightening.

2 Insert the clamp to clamp the strippe

d cable jacket end. Open the

end of the outer conductor a little,

3 Insert the hood between the plastic tape with

aluminium foil and

the outer conductor,

Clamp

Hood

Note: Use the insertion stick to open the hole of about

9. No gap is

allowed in between the clamp, the outer conductor and the hood.