User's Manual Part 3

ROI-S05750 INSTALLATION
2-83
Chart 2-15 (Cont’d)
Step Procedure
9 Tighten the tightening nut sufficiently until the gasket is cut by
the clamp and the tip of the clamp hits the washer,
Note: Torque for the tightening nut shall be 8 to 30N•m.
Note: When tightening the nut, tighten with wr
ench at the wrench at the
wrench flat.
Note: Distance between the tightening nu
t and the LP shell is 1.85 to
2.1 mm for reference.
Tighten the nut sufficiently.
L-type dimension and cutting length of the cable.
Specified length L: Cutting length L−25
.