User's Manual Part 4
Introduction ROI-S05752
-18-
Notes: *1. Not applied.
*2. XPIC configuration only.
*3. Not displayed on LCT.
*4. APS configuration only.
*5. Selectable.
*6. LAN configuration only.
66 OC-3(2) LOS(MUX) No. 2 OC-3 from MUX, loss of signal is detected OC-3 INTFC *1 Major
67 OC-3(1) LOF(MUX) No. 1 OC-3 from MUX, loss of frame is detected OC-3 INTFC Major
68 OC-3(2) LOF(MUX) No. 2 OC-3 from MUX, loss of frame is detected OC-3 INTFC *1 Major
69 OC-3(1) LOS(DMR) No. 1 OC-3 from DMR, loss of signal is detected OC-3 INTFC Major
70 OC-3(2) LOS(DMR) No. 2 OC-3 from DMR, loss of signal is detected OC-3 INTFC Major
71 OC-3(1) LOF(DMR) No. 1 OC-3 from DMR, loss of frame is detected OC-3 INTFC Major
72 OC-3(2) LOF(DMR) No. 2 OC-3 from DMR, loss of frame is detected OC-3 INTFC *1 Major
73 OC-3(1) E-BER(MUX) No. 1 OC-3 from MUX, Excessive-BER is detected OC-3 INTFC Major
74 OC-3(2) E-BER(MUX) No. 2 OC-3 from MUX, Excessive-BER is detected OC-3 INTFC Major
75 OC-3(1) SD(MUX) No. 1 OC-3 from MUX, Signal Degrade is detected OC-3 INTFC Major
76 OC-3(2) SD(MUX) No. 2 OC-3 from MUX, Signal Degrade is detected OC-3 INTFC Major
77 OC-3(1) E-BER(DMR) No. 1 OC-3 from DMR, Excessive-BER is detected OC-3 INTFC Major
78 OC-3(2) E-BER(DMR) No. 2 OC-3 from DMR, Excessive-BER is detected OC-3 INTFC Major
79 OC-3(1) SD(DMR) No. 1 OC-3 from DMR, Signal Degrade is detected OC-3 INTFC Major
80 OC-3(2) SD(DMR) No. 2 OC-3 from DMR, Signal Degrade is detected OC-3 INTFC Major
81 OC-3(1) TF ALM No. 1 OC-3 output to MUX is failure OC-3 INTFC Major
82 OC-3(2) TF ALM No. 2 OC-3 output to MUX is failure OC-3 INTFC Major
83 APS SW FAIL APS switch is failure CTRL *4 Major
84 LAN LINK LAN LINK status Main INTFC *6 Major
85 LAN COLLISION LAN status Main INTFC *6 Status
86 LAN LLF ALM LAN Link Loss Forwarding status Main INTFC *6 Status
87 SPEED & DUPLEX LAN Port setting Main INTFC *6 Status
88 WS INPUT LOSS WS Input signal is lost Main INTFC *6 Minor
89 WS AIS RCVD WS AIS signal is received Main INTFC *6 Status
90 WS AIS GENERATED WS AIS signal is generated Main INTFC *6 Status
95 MODEM ALM1 MODEM1 total alarm MODEM Major
96 MODEM ALM2 MODEM2 total alarm MODEM *1 Major
97 INTFC(1) ALM Main INTFC total alarm OC-3 INTFC Major
98 INTFC(2) ALM Main INTF Sub INTFC OC-3 INTFC/
SUB INTFC
Major
99 CTRL ALM CTRL UNIT total alarm CTRL Major
100 MODEM 1 UNEQUIP MODEM1 is unequipped CTRL Major
101 MODEM 2 UNEQUIP MODEM2 is unequipped CTRL Major
102 INTFC(1) UNEQUIP MAIN INTFC is unequipped CTRL Major
103 INTFC(2) UNEQUIP SUB INTFC is unequipped CTRL Minor
104 INPUT VOLTAGE ALM1 PS1 input over voltage/lower voltage MODEM No.1 Major
105 INPUT VOLTAGE ALM2 PS2 input over voltage/lower voltage MODEM No.2 *1 Major
106 INTFC (1) TYPE MISSMATCH Mounted INTFC differs from configuration setting Main INTFC Major
107 INTFC (2) TYPE MISSMATCH Mounted INTFC differs from configuration setting Main INTFC Major
108 OC-3 (1) OUTPUT CONTROL MS-AIS control for MUX Main INTFC *5 Status
109 OC-3 (2) OUTPUT CONTROL MS-AIS control for MUX Main INTFC *5 Status
110 OC-3 (1) APS LOCKIN STATUS APS is in lockin Main INTFC *4 Status
111 OC-3 (2) APS LOCKIN STATUS APS is in lockin Main INTFC *4 Status
Table 1-1 ALM/STATUS List (SONET) (2/2)
No. ALM/STATUS ITEM EVENT STATUS
SOURCE OF
EVENT
Configuration
Criteria
Default
1+0 1+1