User's Manual

78
iPasolink250 Installation and Commissioning Guide Document ID: 141-DOC000008-E
2. Slide in the card along the guide ways provided on the chassis with the ejector levers in the
horizontal position to engage the ejectors to the chassis groove.
3. Operate the two ejector levers (inwards) simultaneously to engage the card to the backplane.
4. Fasten the face plate to the chassis using Philips (PH1) screwdriver. Apply 0.7 N-M torque
when tightening the screws with the chassis.
RISK OF PERFORMANCE DEGRADATION: Failure to fasten the face plate to the
chassis may result in intermittent failures, because of poor connectivity.
To eject a card from the network element:
1. Identify the card that is to be ejected.
Figure 25: Inserting Card into the Chassis
Figure 26: Pushing Ejector Lever Inwards