User's Manual

Radio Frequency (RF) Signals

THIS MODEL PHONE MEETS THE U.S. GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO

RADIO WAVES.

Your wireless phone contains a radio transmitter and receiver. Your phone is designed and

manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the

Federal Communications Commission of the U.S. Government. These limits are part of comprehensive

guidelines and establish permitted levels of RF energy for the general population. The guidelines are

based on standards that were developed by independent scientific organizations through periodic and

thorough evaluation of scientific studies.

The exposure standard for wireless mobile phones employs a unit of measurement known as the

Specific Absorption Rate (SAR). The SAR limit set by the FCC is 1.6 W/kg.* Tests for SAR are

conducted using standard operating positions accepted by the FCC with the phone transmitting at its

highest certified power level in all tested frequency bands. Although the SAR is determined at the

highest certified power level, the actual SAR level of the phone while operating can be well below the

maximum value. This is because the phone is designed to operate at multiple power levels so as to

use only the power required to reach the network. In general, the closer you are to a wireless base

station antenna, the lower the output.

Before a phone model is available for sale to the public, it must be tested and certified to the FCC that

it does not exceed the limit established by the U.S. government-adopted requirement for safe

exposure. The tests are performed on position and locations (for example, at the ear and worn on the

body) as required by FCC for each model. The highest SAR value for this model phone as reported to

the FCC when tested for use at the ear is 0.714 W/kg, and when worn on the body, is 0.644 W/kg.

(Body-worn measurements differ among phone models, depending upon available accessories and

FCC requirements). While there may be differences between the SAR levels of various phones and at

various positions, they all meet the U.S. government requirement.

The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels

evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model

phone is on file with the FCC and can be found under the Display Grant section at https://

gullfoss2.fcc.gov/oetcf/eas/reports/GenericSearch.cfm after search on FCC ID A98-7N2S12A.

For body worn operation, this phone has been tested and meets the FCC RF exposure guidelines

when used with an accessory designated for this product or when used with an accessory that

contains no metal and that positions the handset a minimum of 1.5 cm from the body.

* In the United States, the SAR limit for wireless mobile phones used by the public is 1.6 watts/kg (W/kg) averaged

over one gram of tissue. SAR values may vary depending upon national reporting requirements and the network

band.

PAGE 1
Radio Frequency (RF) Signals THIS MODEL PHONE MEETS THE U.S. GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO RADIO WAVES. Your wireless phone contains a radio transmitter and receiver. Your phone is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population.
PAGE 2
FCC Regulations This mobile phone complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This mobile phone has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.