User's Manual

12
Voice/Videophone Calls
● When you receive a FOMA voice or
videophone call with a message
The Chaku-moji appears on the ringing screen. The
Chaku-moji disappears when you answer the call.
z The received Chaku-
moji is displayed in
3D animation.
● Displaying a message from Received calls
When you receive Chaku-moji, the “ ” icon
appears on the Received calls entry, and you can
check the Chaku-moji on the “Received calls” screen
(detail).
Showing/Hiding Caller ID
When Making a Call
Adding the “186”/“184” prefix to the
other party’s phone number
To show your caller ID, add the “186” prefix when you
dial the phone number. To hide your caller ID, add the
“184” prefix.
z This function cannot be used for a WLAN voice call.
■To show your phone number
186 - (The other party’s phone number)X
r (voice call) or [ch] (V.phone)
■To hide your phone number
184 - (The other party’s phone number)X
r (voice call) or [ch] (V.phone)
Showing/Hiding your caller ID from the
function menu
Show/Hide your caller ID using the function menu of a
detail screen such as “Enter phone number” screen,
“Phonebook”, “Received calls”, “Dialed calls” or
“Redial”.
<Example: To make a FOMA voice call from the Enter
phone number screen>
1
Enter the phone number of the
other party
2
[MENU] (FUNC)X“Notify Caller
ID”X“OFF” or “ON”
N
z Charges apply to send Chaku-moji. Charges do
not apply to receive Chaku-moji.
z You can store up to 30 Chaku-moji in Sent
messages (Regardless of the modes in the use of
2in1, up to 30 Sent messages are stored in A and
B numbers, respectively). When you send the
same Chaku-moji repeatedly, only the latest one is
recorded. When the number of entries exceeds
the maximum, older entries are overwritten.
z If the receiver’s handset is under the following
conditions, Chaku-moji cannot be sent. In this
case, no sending charges apply.
• The handset does not support Chaku-moji
(“Transmission failed” appears)
• Chaku-moji does not appear on the receiver
display due to the “MSG display settings” on the
receiver handset (“Transmission failed” appears)
• Public mode (Driving mode) is set
• The ringing time for Record message is set to 0
second
• “ ” is displayed or the power is off
z Depending on the signal quality, the transmission
result may not appear on the sender terminal even
when the receiver terminal receives Chaku-moji.
In this case, sending charges apply.
z You cannot send or receive Chaku-moji overseas.
N
z Even when you receive a call whose ring tone
sounded for a shorter time than the time set in
“Set mute seconds” under “Ring time (sec.)”,
Chaku-moji is displayed and recorded in Received
calls.
z Some pictograms are not displayed in 3D
animation.
z Depending on the status of the sender or receiver,
Chaku-moji may not be displayed even when you
receive a call with Chaku-moji.
Ex: FOMA voice call
Chaku-moji
z You can store up to 30 Chaku-moji in Sent
messages (when 2in1 is active, up to 30 sent
messages are stored for Number A and up to 30
for Number B regardless of the mode).
N
z Even when you make a call using the Received
calls entry, the Chaku-moji in the entry is not sent.
N
REA_Tel.fm 12 ページ ２００９年７月３１日 金曜日 午後１０時４分