User's Manual

5
Continued on next page
Voice/Videophone Calls
Visual check⇔Visual check off……View yourself
with the front camera during a videophone call.
Otherwise, end checking. “ ” appears and the
substitute image is sent to the other party during
visual check.
V.phone settings……Set the screen for videophone
calls.
Visual prefer.……Select Normal/Prefer img
qual/Prefer motion spd for an image sent to and
received from the other party. This setting is only
retained during the call.
Brightness……Adjust the brightness between
five levels (–2 to 0 to +2).
White balance
Color mode set……Select Normal/Sepia/
Monochrome as an image effect. This setting is
only retained during the call.
Chara-den set.……Set the following when Chara-
den is used. This setting cannot be set for the camera
images.
Switch Chara-den, Action List, Change
Action
Switch image……Display an image selected in
“Substitute image” (p.24) on the other party’s
display.
Display light……Turn on the light all the time or
follow the “Lighting” settings under “Backlight”.
FrontCamera Rev.……Set whether to display your
camera image as a mirror image (ON) or normal
image (OFF) on your FOMA terminal during a call.
Own number……Display your phone number during
a videophone call.
Send DTMF tone⇔ DTMF tone OFF……Set/
Release push signal transmission mode during
Chara-den. Videophone calls other than Chara-den
are always in push signal transmission mode.
Change to voice→p.6
Loc. notification
● If a videophone call is not connected
When a videophone call is not connected, the cause
of the failure appears.
z The cause may not appear depending on the
situation.
z Depending on the type of the other party’s phone or
network service subscription, the reason may not
accurately reflect the other party’s actual status.
Display Cause
Check number
then redial
The dialed phone number is
not in use
Busy The line is busy
• This message may also
appear during packet
communication, depending
on the other party’s
terminal.
Busy with packet
transmission
The other party is using
packet communication
Out of service
area/power off
The other party is out of
FOMA range or the phone is
turned off
Your call is being
forwarded
The call is being forwarded (a
videophone call is made
when the forwarding number
is for a 3G-324M-compatible
videophone)
Redial using voice
call
The forwarding phone is not
compatible with videophone
Please activate
caller ID before
dialing again
The other party has set the
Caller ID request service
This number is not
available
The other party has set the
Nuisance call blocking
service
Upper limit has
been exceeded
Connection failed
The upper limit set for a Limit
billing plan (Type Limit or
Family Wide Limit) is
exceeded
Connection failed You attempted to connect
without notifying your caller
ID (when dialing into
visualnet, etc.)
• This message may also
appear in other situations.
Set Caller ID Notification to
“ON” and retry.
Please make your
call from the
i-mode web page
You attempted to make a
videophone call to watch
V-live without browsing the
i-mode official site
REA_Tel.fm 5 ページ ２００９年７月３１日 金曜日 午後１０時４分