User's Manual

---------------------------------------------------------------------------------------------

- 9 -

Rear View

7 Jumper Blocks

These blocks of jumper locations set the configuration for the DVD R/RW drive.

(See page 10, “Jumper Setting” for details.)

8 DIGITAL OUT Connector

This connector is used to connect CD Digital Audio to an audio board.

9 Line Out Connector

This connector is used to connect CD-Audio to an audio board.

10 I/O BUS Connector

This BUS connector is used to control the DVD R/RW drive and sent data.

Use a flat ribbon cable to connect your computer to the DVD R/RW drive.

Connect the colored side of the ribbon cable to the side marked with the arrow.

11 Power Connector

Use this to provide operating power from the host computer.