User's Manual
7
of
5
1
/LFHQVHIRUPDLQWHQDQFHXSJUDGHIXQFWLRQ
Maintenance version update function automatically updates through the
Internet when there is an important change in the software of this product.
"Important Update" means it indicates that NEC Platforms, Ltd.
(Hereafter assumed as "Our company") will provide the software
version upgrade of the functionality (For example, software update to
improve security failure, etc.) of this product when it is determined to
be required. When there is an important update, you will be guided in the
"Important News" of our home page (
https://www.necplatforms.co.jp/
).
Since this product reboots when maintenance version upgrade of the
functionalities begins to operate while connecting, connected
communication is cut until then. In addition, in the case of metered billing
contracts, communication cost may occur due to software downloads,
speed limit occurs due to packet transmission excess amount.
In this function, among the information with regards to this product, we
notify the server that we operate for the minimum required equipment
information and network information in order for this function to operate.
These information are used only for the implementation of this function,
and the improvement and enhancement of this product and function.
Moreover, appropriate management of these information is performed in
accordance with our company's handling procedures. When we use this
function in cooperation with a third party, appropriate management is
implemented similar to our handling procedure.
The initial value of this function is enabled. When you cannot get the
license, please disable the function according to the following procedure.
However, when you disable this function, update is not done automatically
even if there are critical software updates that improve security failure.
When you keep using the software before it is improved, there is a
possibility that the danger done by an illegal access from a malicious third
party may remain.
<How to stop>
(1)
Start the Web setup. (p35)
(2)
Click ³Maintenance´ on the Top page.
(3)
Select ³
Maintenance´ then ³Maintenance´.
(4)
Remove the check on [Enable] in ³Maintenance Update´.
(5)
Click ³Apply´.