Server Operation Manual

Base Module
855-900549 2-76
2.4.6.12. SG (SP/System Setting)
m B u
X X X
* Always valid without regard to the current system status.
Function:
This command is used to make various system settings and configure the iSP operation
environment.
Main Menu Sub Menu Config. Parameter Remarks
System common settings
(maintenance only) (*1)
System common
Partition settings
(maintenance only) (*1)
Partition configuration Valid after a next
partition boot
Partition boot methods
and Hot-Plug permission
Setting for the means
of partition boot and
hot plug enable
Valid after a next
partition boot
System
configuration
settings
display all settings Show all system
settings on console.
LAN/Serial settings LAN/serial port
configuration
After a
configuration
change, iSP need
be reset.
FTP server settings FTP server settings
SNMP settings SNMP-related
configuration
After a
configuration
change, iSP need
be reset.
iSP settings
(*2)
display all setting Show all iSP settings
on the console.
display all
settings
N/A Show all system and
iSP settings on the
console.
(*1) Changes to configuration parameters are only allowed in the Maintenance mode.
(*2) In a duplicated iSP environment, iSP configuration must be done on each of the duplicated
iSPs.
Setting partition boot method and hot-plug permission:
Category Configuration Parameter Default Setting
AC Link
[AC LINK MODE]
Specifies whether or not the partition is to be
booted immediately when an AC power is
applied.
off
For each partition
Wake on
LAN
[Wake on LAN]
Specifies whether partition boot by Wake on LAN
is enabled or not.
off