User Manual

English-20
MENU Tools
LANGUAGE
Selects the language used by the OSD.
OSD TURN OFF
The OSD menu will stay on as long as it is in use. You can select how long the monitor waits after the last touch of a
key to shut off the OSD menu. The preset choices are 10-120 seconds by 5-second increments.
OSD LOCK OUT
This control completely locks out the access to all OSD control functions except for BRIGHTNESS, CONTRAST and
VOLUME.
To activate the OSD Lock Out function, enter the OSD menu, select OSD LOCK OUT, then touch “INPUT/SELECT”
key and RIGHT key simultaneously. To deactivate, touch “INPUT/SELECT” and LEFT keys simultaneously.
HOT KEY
When this function is activated BRIGHTNESS, VOLUME and USB SELECT can be adjusted without entering the OSD
menu by using the front keys.
ON: The “
/RESET” key on the bezel is enabled MULTI PICTURE settings.
Touch the UP key to show brightness menu. The LEFT/RIGHT keys adjust the brightness level.
Touch the DOWN key to show volume menu. The LEFT/RIGHT keys adjust the volume level.
Touch the RIGHT key to show USB SELECT menu. The LEFT/RIGHT keys select USB upstream ports.
You can swap pictures between a main screen and a sub screen by touching the /RESET key for 3 seconds or
more while Main or Sub is set in MULTI PICTURE.
NOTE: Swapping of picture by picture is not supported. The sound keeps the value of SOUND INPUT setting.
The expansion keeps the values of EXPANSION setting of each input.
OFF: The HOT KEY function for “
/RESET” key, “LEFT/RIGHT” key and “DOWN/UP” key functions are disabled.
SIGNAL INFORMATION
If you select “ON”, monitor displays “VIDEO INPUT MENU” after changing the input.
If you select “OFF”, monitor doesn’t display “VIDEO INPUT MENU” after changing the input.
SENSOR INFORMATION
If you select “ON”, monitor displays “HUMAN SENSOR ON” message. If you select “OFF”, monitor doesn’t display
“HUMAN SENSOR ON” message.
KEY GUIDE
If you select “ON”, the Key Guide appears on screen when the OSD menu is accessed.
DATA COPY
To initiate data copy from the master monitor to the sub monitor(s), select “DATA COPY” and touch the “INPUT/
SELECT” key. A “PROCEEDING...” indicator will appear on the screen.
NOTE: This function is only intended for the master monitor in ControlSync.
All of the settings specifi ed in the ControlSync chart (see page 11) will be copied from the master monitor to
the sub monitor(s).
CUSTOMIZE SETTING
Store the current settings for easy recovery.
To store current settings: Touch the “INPUT/SELECT” key. After a warning message appears, touch the
/RESET” key, current settings are stored.
To restore settings: Hold “MENU” for 3 seconds or more while the OSD menu is off.