User Manual

ManualsBrandsNEC ManualsComputer MonitorsEA295WMI-BK 29" 21:9 Ultrawide IPS Monitor

English-6

3. Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and lift up to the highest position.

4. Connect all cables to the appropriate connectors (Figure C.1). When using the USB cable, connect the B type connector

to the USB upstream port on the right back side of the monitor and the A type connector to the downstream port on the

computer (Figure C.1a). If using the cord from a USB device, plug into the downstream port of the monitor.

NOTE: Incorrect cable connections may cause abnormal operation, damage display quality/components of LCD module and/

or shorten the module’s life.

NOTE: Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor turns down the sound.

NOTE: Adjustment of the volume control as well as the equalizer to other settings than the center position may increase the

ear-/headphones output voltage and therefore the sound pressure level.

Figure C.1

Power cord

30° Tilt

HDMI2

Figure C.1a

A Type

B Type

A Type

B Type

Highest Stand

Position

Audio Input

USB 3.1 Gen 1 Downstream

(USB Type-A)

Headphone

USB 2.0 Downstream (USB Type-A)

ControlSync OUT*

D-SUBHDMI1

DisplayPort

DisplayPort IN

USB 3.1 Gen 1 Upstream (USB Type-B)

DisplayPort

DisplayPort OUT*

ControlSync IN

: See page 10.

: Remove the DP cap when using the DP out connector. See page 12.

5. To keep the cables neatly organized, place them into the cable management system that is built into the stand.

Place the cables in the hooks ﬁ rmly and evenly (Figure C.2 and Figure C.3).

NOTE: Cable cover is not removable.

6. Please check that you can still rotate, raise and lower the monitor screen after you have installed the cables.

Figure C.2 Figure C.3

Power Cord

DisplayPort Cables

D-SUB Cable

HDMI Cables

Audio Cable*

ControlSync Cables

USB Cables