user manual

CHAPTER 2 ND-70185 (E)
Page 4
Revision 3.0
GENERAL
Free Numbering
2. Free Numbering
A Telephone Number can be assigned to a desired station on the Fusion network using the simple command
operation shown below.
Figure 2-2 Free Location
2.1 Centralized Maintenance Administration Terminal (MAT)
A Fusion network has one Network Control Node (NCN) and Local Nodes (LNs). The NCN has the Cen-
tralized-MAT, which runs on Windows 95/NT. The MAT can collect fault information from all nodes on
the network. The NCN has Network Data Memory, which stores the data related to network level. The Tele-
phone Numbers, for example, can be changed using the Centralized-MAT at the NCN. The MAT also al-
lows the user to manage network-level office data.
Figure 2-3 Centralized MAT on Fusion Network
Telephone Number
411111
NCN
LN
Node A
Node B
STN 2000
STN 2000
STN 2000
STN: Physical Station Number
NCN: Network Control Node
LN: Local Node
In this figure, the user is changing the location of Telephone Number "411111" to Node B.
user
Telephone #: 411111
STN: 2000
Telephone #: 411111
STN: 2000
Node A
Node B
Note
Note: The ALGSN command is used for assigning Telephone Numbers. See 5.6 "Assignment of Telephone Numbers" for more
detail.
MAT
Node C
LN
Fusion Network
C
h
a
n
g
e
l
o
c
a
t
i
o
n
Node A
Node B
NCN
LN
Node A
Node B
Node C
LN
Node B
December 12 1997
AM 3:12:13
Node B FCH Failure
MG: 00
U : 02
G : 11
:
:
:
FCH fault....
Fault Information
Fault Information
Fault information can be collected at NCN via Fusion Link.
MAT
PRT
Fusion Network
Fusion Link
NCN: Network Control Node LN: Local Node
13-H
1. xxxx xxxx 0010 1222
4. x0010 1110 10110 1FFF
7. E23C CAAB12 000 0000
13-H
1. xxxx xxxx 0010 1222
4. x0010 1110 10110 1FFF
7. E23C CAAB12 000 0000
NEC
Note
Note:
Actual system message is indicated in a different format.