user manual

ND-70185 (E) CHAPTER 8

Page 191

Revision 3.0

EX- FCCS

Data Programming

STEP 3: AFUGN

Assign EX-FCCS Fusion Group data. Designate Self-FUG Number, Connection FUG Number and

Fusion Point Code (FPC) of the NCN within each FUG. Either of FUG is set as the Center FUG by

checking the “CENTER” parameter.

STEP 4: AEXFN

Assign the EX-FCCS CCH Selection Data by designating all the Fusion Point Code (FPC) and the

Point Code (PC) in the connected Fusion Group.

Note:

Confirm whether the data assignment is correctly performed by logging in to each node with Centralized

MAT. Reexamine the assigned system data if log-in can’t be activated. There may be some error in data

setting so far.

4.1.2 To Access EX-FCCS Trunk via ACC + Telephone Number

Assign the data at all the nodes in the EX-FCCS network. For each NCN, perform the data setting from

STEP 1 through STEP 7. For other Local Nodes, the assignment of STEP 5 and STEP 6 is required. Just

for the NCN of the Center Fusion Group, assign EX-FCCS Telephone Number data using AELGN com-

mand.

STEP 1: ANPDN

Assign Numbering Plan Data referring to the following example using ANPDN command.

STEP 2: ASPAN

Assign Special Access Code, using the ASPAN command referring to the following example. Note

that “LCR” must be selected in the ASPAN command to activate EX-FCCS features.

STEP 3: AFRSN

Assign NPC (Number Pattern Code) and OPR (Outgoing Route Selection Number) for dummy route

number.

STEP 4: AOPRN

Assign the routes and in what order these routes will be selected corresponding to the data assigned

by AFRSN command.

TN: 1 1st DC: 8 CI: N/H NND: 3 BLF:0

TN: 1 ACC: 820 C1: N/H SRV: LCR

RT: 31 2nd DT: 0 AH: 0 SUB: 0

Note:

In this example, RT31 is dummy route.