user manual

CHAPTER 8 ND-70185 (E)

Page 192

Revision 3.0

EX- FCCS

Data Programming

STEP 5: ARNPL

Assign the access code for LCR/LCRS as assigned in ASPAN associated with the logical routes for

each external trunk assigned in ARTD/ARTDN.

STEP 6: AMND

Assign the Maximum Necessary Digit (MND).

Note 1:

The MND is the total number of ACC + Telephone Number.

Note 2:

Refer to CHAPTER 5, Section 7.1 “Assignment of Access Code for Tandem Connection via FCCS - ACIS“

for more detail data programming related to LCR/LCRS such as AFRSN, AOPRN, ARNPL and AMND com-

mand.

STEP 7: AEADN

Assign the ADC (Abbreviate Digit Code) for Connection Fusion Group. Enter the FUG Number as-

signed by AFUGN command, TN, and ADC to be assigned.

Note:

Check whether the trunk originating call via CCIS can be executed by dialing ACC + Telephone Number

here. Reexamine the assigned numbering plan data if the call cannot be connected. There may be some er-

ror in data setting so far.

4.1.3 To Access EX-FCCS Trunk via EX-FCCS Telephone Number

AELGN: Telephone Numbers must be assigned for all the station within the network uniquely. Use AELGN

command to allocate EX-FCCS Telephone Number. FUG data must be assigned previously by

AFUGN command to activate this command.

Only readout function can be used by this command in case both the Self FUG Number and the Con-

nection FUG Number are assigned, if the Self FUG is not the Center FUG.

Note:

Check whether the trunk originating call via CCIS can be executed by dialing EX-FCCS Telephone Num-

ber. Reexamine the assigned numbering plan data if the call cannot be connected. There may be some error

in data setting.