user manual

NDA-24233 Issue 2 Page 3-55
VisuaLink 128/384 Engineering Guide Console Command List
3.20 Camera Control Command
CAMS Request for Camera Direction Change 20-1
Description: Sets camera head swing control. This command is valid only when an
preset or auto mode camera is in use. A control of Camera 2 is only valid
when the camera is the EVI-D30 type.
Command Format: CMAS p1 p2
p1: L1-2 : local camera 1/ 2 control
R1-2 : remote camera 1/ 2 control
p2: 1-9 : preset number
Z x : zoom change
F x : focus change
P x : pan change
T x : tilt change
UP x : diagonally upper direction
DP x : diagonally lower direction
H : center
Note:
x: + : positive direction
- : negative direction
0 : stop moving (changing)
Response: Normal Response OK
Error Response: ERR01
ERR11
ERR12
ERR16
ERR20
ERR27
T+
UP+
UP-
P+ P-
DP-
T-
DP+