user manual

ND-20292
CHAPTER 3
APRIL, 1990
$$PKR - ON/OFF Line
TEL # - Enter new DWBLF device number
F/W -
CLEAR - Clears previous assignment
ENTER - Enter each assignment
B/W -
GUIDE TO FEATURE PROGRAMMING
MEMORY BLOCK THAT MEMORY BLOCK THAT MAY
CPU-EB or higher.
NOTES:
1. If TEL # key is depressed (any time after step
4) the program is returned to step 3.
2. Depressing the ENTER key will return you to
Step 3.
3. The flexible function keys will not operate on a
DSS/BLF unit assigned as a CO Add-On
module.
4. DSS to Attendant Assignment (1Cl) must be
vacant before assigning the EDE-30-1 as a CO
Add-On module.
5. The CO Add-On module device number (l-4)
will automatically associate the CO Add-On
module to an attendant position (l-4)
respectively and cannot be changed.
; GENERAL INFORMATION - DSSTO CO ADD-ON MODULE ASSIGNMENT ;
i
I
i
i
i This area of the memory block is used to assign EDE-30-1 DSS/BLF units to function as CO Add-On i
f Modules. A maximum of four (41 DSS/BLFs can be assigned as CO Add-On Modules, this impacts the 1
i overall limit of six (6) DSS/BLF units that can be installed in a system. It is possible for an Attendant to be i
I assigned two (2) DSSBLF consoles and one (1) CO Add-On Module. Only an EDE-30-1 Revision B or higher f
: can be assigned as a CO Add-On Module.
I
i
I
~._._.-.-._._.~.-.-.~.~.~.~.-.-.-.~.~.~.-.~.~.~.-.-.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~
300 - 23